Transducer Design Questionnaire

Name*
Email*
Telephone Number*
Questions
Drive Signal Type:
Pulse Width or Burst Length if appropriate:
Drive Signal Amplitude (in Volts – peak):
Mode of Operation:
Required Acoustic Output at focus or far field position:
Centre Frequency (in MHz):
Required Bandwidth OR Q factor:
Diameter of active area (in mm):
Flat or Focussed:
Focal Length (in mm):
Transducers are normally supplied with a BNC Output Connector on a 1.5m cable but if you require an alternative please indicate it here.
Electrical Impedance (in Ohms):
Any other design requirements:
CAPTCHA
Comments

This field is for validation purposes and should be left unchanged.